Let me start with Initial Setup/Securing you Cisco Switch/Router..I am using Secure CRT software to configure my Cisco switch.
==============================================================
Initial Setup
==============================================================
enable
conf t
int fa 0/0
ip add 192.168.10.1 255.255.255.0
no shut
exit
hostname (your hostname)
enable secret (your password)
service password encryption
no ip domain lookup
line con 0
password (administrative pw)
logging synchronous
exit
line vty 0 14
password (your password)
end
==============================================================
Reserving DHCP
==============================================================
Conf t
ip dhcp excluded-address 192.168.10.1 192.168.10.20 <-example ip>
ip dhcp excluded-address 192.168.10.240 192.168.10.255 <-example ip>
ip dhcp pool data
network 192.168.10.0 255.255.255.0 <your Network IP>
default-router 192.168.10.1 <Default Gateway>
dns-server 8.8.8.8 4.2.2.2 <DNS Server>
option 150 ip 192.168.10.1 !<---TFTP server
end
===============================================================
configuring Analog phone system
===============================================================
conf t
voice-port 0/0/1 <- port where the analog phone is connected.>
cptone PH <- can be set to US or any counter/location.>
signal loopstart < or groundstart. If you using a PBX, set to groundstart. If regular analog phone loopstart)
comfort-noise
exit
dial-peer voice 10 pots <change to other value if you're adding another analog phone >
destination-pattern 8888 <- Any # you assign >
port 0/0/1 <- port where the analog phone is connected.>
end
ex.
phone 1
conf t
voice-port 0/0/1
cptone PH
signal loopstart
comfort-noise
exit
dial-peer voice 10 pots
destination-pattern 8888
port 0/0/1
end
phone 2
conf t
voice-port 0/0/2
cptone PH
signal loopstart
comfort-noise
exit
dial-peer voice 11 pots
destination-pattern 7777
port 0/0/2
end
csim start (number) <command to test if the phone is working>
===============================================================
Configuring IP Phones
===============================================================
conf t
telephony-service
max-ephone 10 < can be changed depending on how many IP Phones you connect.>
max-dn 10 < can be changed depending on how many IP Phones you connect.>
no auto assign
no auto-reg-ephone
ip source-address 192.168.10.1 < your Default Gateway >
create cnf-files
ephone 1
mac-address fc99.470f.a442 <mac address of your IP phone>
If you can't register, remove your IP Phone from the switch and paste the code below.
conf t
no telephony- service
telephony-service
max-ephone 10
max-dn 10
no auto assign
no auto-reg-ephone
ip source-address 192.168.10.1
create cnf-files
ephone 1
mac-address fc99.470f.a442 <routers mac address>
end
conf t
telephony-service
ephone-dn 1
number 8810
ephone -dn 2
number 8830
ephone 1
button 1:1 3:2
restart
end
===============================================================
Inter-site communication setup
===============================================================
conf t
dial-peer voice 20 voip
destination-pattern YY.. (number)
session target ipv4:200.0.0.Y (IP Address)
dtmf-relay h245-alphanumeric
codec g711ulaw
This is my Day#1 Note.
